Replace Range

Range

Luminance range in the video that should be replaced by different media.

Softnes the transition between pixels in the luminance range and those outside of it.

Lets you provide additional media to the effect.

The user interface varies by host:

The media whose pixels are used to replace areas of the original video that become transparent after applying the color correction.

Controls how media is scaled within the current frame:

Comparing Fit (left), Fill (center) and Stretch (right) methods.

Fit: media is scaled proportionally to fit inside the frame. When the media does not match the aspect ratio of the video frame, some areas remain empty after scaling (pillarboxing or letterboxing).
Fill: media is scaled proportionally to fill the entire frame. When the media does not match the aspect ratio of the video frame, portions of the media fall outside the frame and thus are invisible (unless further scaling is applied).
Stretch: media is scaled non-proportionally to have the same dimensions of the frame. When the media does not match the aspect ratio of the video frame, this results in all geometric features being deformed.

A point parameter centered in the frame by default.

Initial location in the frame

While it is possible to change the X and Y coordinates via the inspector, it is far easier to interact with point parameters directly on-screen:

Set to 1 by default. Only values between 0 and 5 are allowed.

Set to 0° by default.

Controls whether the given media is tiled over the destination frame.